|
[Sponsors] |
April 20, 2009, 22:36 |
mass transfer
|
#1 |
Member
amar
Join Date: Mar 2009
Posts: 31
Rep Power: 17 |
Dear
I have inside my computational domain water-vapor flows over a cold-plate and I'd like to simulate the accumulation of the frost on the surface of the cold-plate with time, but I don't know from where to start in FLUENT, does it consider steady or unsteady state, do I have to choose pressure solver or density solver and so on? please if anyone know I'm looking forward for a reply. Thanks a lot |
|
April 21, 2009, 11:22 |
|
#2 |
New Member
Join Date: Apr 2009
Posts: 4
Rep Power: 17 |
Hello amar,
Fluent has solidification and Melting model. you can refer a tutorial on this in the basic tutorial list.however i feel your expectations are little on the higher side. i know that deicing can be done, i.e. melting on ice. you can cross check with fluent support. if you are from india you can contact india support. |
|
September 22, 2009, 01:34 |
|
#3 |
New Member
|
Amar,
Have you find any solution for above mentioned simulation. even i am also looking for same solution. if you through with simulation please let me how to simulate this. GauravB |
|
September 26, 2009, 19:53 |
reply
|
#4 |
Member
amar
Join Date: Mar 2009
Posts: 31
Rep Power: 17 |
Hi GauravB,
I have not go through this type of simulations yet, and of course when I will start I'd like to share my experience with. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
About phase change heat and mass transfer | Michael | FLUENT | 2 | February 13, 2011 01:49 |
free convective and diffusive mass transfer | rajani | FLUENT | 0 | July 27, 2005 08:28 |
mass transfer by source | panneerselvam.R | CFX | 7 | July 12, 2005 10:07 |
Vof, udf and mass transfer panel | Jay | FLUENT | 1 | March 15, 2005 00:29 |
additional variable mass transfer in CFX5.6 | john | CFX | 1 | February 14, 2004 00:30 |