|
[Sponsors] |
July 17, 2009, 21:16 |
Particle Tracking
|
#1 |
New Member
yu hou
Join Date: Jun 2009
Posts: 2
Rep Power: 0 |
Hi, I am working on a droplet evaporation in a jet case. Once the run is finished, I can only plot droplet diameter vs time. I can not plot droplet diameter(or any other droplet information) vs the location. I would like to have the x,y,z and droplet diameters at that x,y,z location. I can't find a option. Can anyone help? Thank you very much.
yu |
|
July 18, 2009, 19:11 |
Particle Tracking
|
#2 |
New Member
Josh Kemp
Join Date: Jul 2009
Posts: 1
Rep Power: 0 |
You need to add a surface rake at the desired cross-section, then you plot the droplets vs x &y coordinates.
|
|
July 18, 2009, 22:41 |
|
#3 |
New Member
yu hou
Join Date: Jun 2009
Posts: 2
Rep Power: 0 |
So, I can not have x,y,z and the droplet. I must make a few cross sections to see the droplets at different stage?
|
|
July 20, 2009, 13:38 |
|
#4 |
Member
|
You can write the droplet paths/diameters/release time to a file from the DPM tracking panel.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
particle tracking | Wenqing Zhang | CFX | 15 | August 3, 2013 06:02 |
Number density tracking rather than particle tracking | Rebecca | Main CFD Forum | 2 | April 23, 2009 12:52 |
DPM UDF particle position using the macro P_POS(p)[i] | dm2747 | FLUENT | 0 | April 17, 2009 01:29 |
restarting lagrange (particle tracking) simulation | dbdias | CFX | 0 | September 22, 2007 19:26 |
particle tracking | Gab | CFX | 0 | January 5, 2006 16:12 |