|
[Sponsors] |
December 17, 2009, 04:33 |
3D analysis of Ahmed body
|
#1 |
New Member
Irshad
Join Date: Dec 2009
Location: Bangalore
Posts: 19
Rep Power: 16 |
Hi everybody,
I have a doubt in 3D analysis of Ahmed body. Academically I used to do 2D analysis in fluent. But when I got the resources to in 3D I have following doubts. 1. Since we build the wind tunnel for analysis, after solving the problem I couldnot find the results inside (transparent). Usaually in gambit I have subtracted the body from tunnel and meshed it. So what is the option i need to use in fluent 6.3.26 to find the complte flow of picture in 3d? I am able to see by using the mid plane section view results as like 2D analysis and rear plane view also by defining the mid plane surface. But I need to see in isometric format. 2. when we generally calculate y+ values: either before the analysis or after the analysis? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drag over Ahmed body | Shamoon Jamshed | FLUENT | 2 | May 18, 2009 14:15 |
Can't get good results on ahmed body research | Michael | Main CFD Forum | 8 | September 17, 2008 13:55 |
Flow around the ahmed body (large eddy simulation) | Benzamia | CFX | 0 | February 26, 2007 05:03 |
AHMED BODY (LARGE EDDY SIMULATION) | Benzamia | FLUENT | 0 | February 26, 2007 04:59 |
aerodynamic of Ahmed body | VORTEX | FLUENT | 1 | August 7, 2006 20:48 |