|
[Sponsors] |
May 13, 2010, 05:48 |
HELP; Joining mesh's in fluent
|
#1 |
New Member
Ed Smart
Join Date: May 2010
Posts: 1
Rep Power: 0 |
HI,
Im trying to model a diffuser. I have created the part in NX5 and meshed the part to differnt node sizes i.e. finer mesh at the diffuser, larger mesh underneath the car. I have tryed to join the meshes with interfaces and coupled the different 'bodies' together however when i run the soloution it only solves to the first interface. sometime it comes up with the error message 'Note: zone-surface: cannot create surface from sliding interface zone. Creating empty surface.' How can i join the bodies to allow the air to flow through the whole model? Thanks |
|
May 13, 2010, 12:00 |
|
#2 |
New Member
Tez
Join Date: Oct 2009
Posts: 12
Rep Power: 16 |
Probably you have created a wall at the interface. When you import mesh into fluent, all undefined outer boundaries are labeled as wall. One or more of your interfaces must have become wall. You have to define them as interfaces in pairs. There is a tutorial on non-conformal mesh. I hope that helps you.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
A Problem of Fluent Interpreted UDF: parse error | knight | Fluent UDF and Scheme Programming | 25 | August 16, 2018 10:26 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 8 | July 6, 2010 06:24 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |