|
[Sponsors] |
October 18, 2010, 23:38 |
reading monitor.out file
|
#1 |
Senior Member
raymond
Join Date: Nov 2009
Posts: 149
Rep Power: 16 |
I define the volume monitoring out file. I am able to read it during the modeling. But once I close it and would like to display it again, I do not know how to open it. Does anyone know how to solve my problem? Thanks.
|
|
October 19, 2010, 00:41 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
if you specified the write option, then you have the out file on your hard disk.
You may try to open it, with Plot/file... If you don't succeed, import it into excel, gnuplot or whatever.
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
October 19, 2010, 03:05 |
|
#3 |
Senior Member
raymond
Join Date: Nov 2009
Posts: 149
Rep Power: 16 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Problem converting fluent mesh | vinz | OpenFOAM Meshing & Mesh Conversion | 28 | October 12, 2015 06:37 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
[Gmsh] Compiling gmshFoam with OpenFOAM-1.5 | BlGene | OpenFOAM Meshing & Mesh Conversion | 10 | August 6, 2009 04:26 |
Problem with rhoSimpleFoam | matteo_gautero | OpenFOAM Running, Solving & CFD | 0 | February 28, 2008 06:51 |
Results saving in CFD | hawk | Main CFD Forum | 16 | July 21, 2005 20:51 |