 |
 |
 |
|
|
|
[Sponsors] | ||||
November 21, 2010, 13:18
|
How to draw 2D VAWT in Wrorkbench-fluent
|
#1 |
|
New Member
Low Chee Boon
Join Date: Nov 2010
Posts: 3
Rep Power: 17  |
Hi , everyone. im new in Ansys. i have no idea how to draw a 2D VAWT. can anyone teach me ??
1st i select the Fluidflow(fluent) to project schematic. start the geometry. i draw in x-y plane and extrude 1 to Z-axis. and this method is i saw from others post. is it right ?? if it right. what is the next step ? thx for looking at my problem. boon |
|
|
|
|
|
November 21, 2010, 19:22
|
|
#2 |
|
New Member
Low Chee Boon
Join Date: Nov 2010
Posts: 3
Rep Power: 17 |
T.T
did anyone can tell me where can learn it ?? |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 05:16 |
| Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 04:22 |
| Fluent 6.3 32bit vs Fluent 12.0 64bit | ibex7 | FLUENT | 7 | April 18, 2011 03:44 |
| Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 03:57 |
| to draw tech plot using fluent results(case& data) | madhuri | FLUENT | 2 | July 18, 2007 14:43 |
Linear Mode
