|
[Sponsors] |
February 23, 2009, 08:36 |
Troubles with the dpm model
|
#1 |
Guest
Posts: n/a
|
Hi, I'm Marco Antonelli and I am researcher at the University of Pisa.
I set up a cluster for parallel computing using Fluent 6.3 and I'm simulating the injection of gasoline inside an engine cylinder. When I used a single pc it ran all ok, but since I've been trying using this cluster, I've this trouble with the injection: after some time steps, the calculation is blocked at the dpm injection advance and does nor proceed, neither giving any error. Anyone had the same trouble than me? Thanks Marco |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF troubles | Rachel | FLUENT | 1 | June 29, 2008 23:02 |
AMG troubles - help? | Stephanie | Siemens | 1 | September 22, 2007 14:03 |
3d VOF troubles... | Mac | FLUENT | 0 | March 12, 2007 08:41 |
LAMMPI troubles | mer | OpenFOAM Installation | 4 | September 13, 2005 05:41 |
some video troubles... | giosue | Siemens | 2 | February 19, 2003 10:03 |