|
[Sponsors] |
May 10, 2011, 23:33 |
Fluent won't Y+ adapt
|
#1 |
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
Hey guys,
Made a model of a car with a spinning wheel (one only - baby steps). The pressures on the car look way wrong; most of the car is extremely high, but the wheel has very low pressure. The velocity streamlines look alright. Funny thing is when I run the y+ adaption routine, fluent marks ~500000 cells for coarsening (using ke), but it never changes any. It always reports 0 cells are changed. Anyone ever run into this before? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 8 | July 6, 2010 06:24 |
Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 02:57 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |