|
[Sponsors] |
June 22, 2011, 11:55 |
node number vs convergence
|
#1 |
New Member
Mike
Join Date: Apr 2011
Posts: 22
Rep Power: 15 |
Hi,
Im running a 2D airfoil at M=0.8 and Re=6.5E6 and ive noticed that with 40,000 nodes or around there a solution is calculated on the mesh and accuratly but now im running my grid independance study and i tried doubling and tripling my node count and found that the solution diverged. I was wondering why this would be the case that with a higher node count the case would diverge |
|
June 22, 2011, 12:25 |
|
#2 |
Member
Nuno Gomes
Join Date: May 2009
Location: Portugal
Posts: 39
Rep Power: 16 |
maybe your mesh quality get worst....you should see the skewness and try to be below of 0,84
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 13:06 |
[mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 12:55 |
convergence problem when use pisoFoam, LES for wind tunnel case | Forrest_Lei | OpenFOAM | 3 | July 19, 2011 06:00 |
Node Spacing and number of nodes | hagupta | CFX | 1 | June 12, 2006 06:45 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |