|
[Sponsors] |
March 6, 2012, 07:32 |
Vacuum Pressure at Outflow
|
#1 |
Member
Join Date: Nov 2011
Posts: 42
Rep Power: 14 |
Hi guys,
Basically I am injecting air in at atmospheric pressure from one end. Whilst at the other end there is a vacuum pump sucking out the air. I take it I will have to use a pressure outlet BC. However its asking for a gauge pressure and this is boggling me because absolute = atmospheric + gauge. (thus my operating pressure is at 0 for gauge pressure) Since i am operating below atmospheric that means gauge has to be negative but then hysys does not allow me to do that. Or am I completely missing the point? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure Outlet Guage pressure | Mohsin | FLUENT | 36 | April 29, 2016 17:16 |
Setup/monitor points of pressure and force coefficients | siw | CFX | 3 | October 22, 2010 06:07 |
Pressure enigma. | Sara | Main CFD Forum | 22 | July 30, 2009 04:46 |
Pressure outflow w/ species; mass frac. required? | Myth | FLUENT | 2 | September 29, 2006 23:08 |
Hydrostatic pressure in 2-phase flow modeling (CFX4.2) | HB &DS | CFX | 0 | January 9, 2000 13:19 |