|
[Sponsors] |
January 25, 2006, 06:21 |
Wall function
|
#1 |
Guest
Posts: n/a
|
For a fine mesh (say y plus less than 3) a simulation was performed using standard wall function in two equation model for some iterations say 1500 and after that the wall function was removed and the run was carried out for another 1500 iterations. Whether the results after 3000 iteration will predicit the near wall behaviour correctly.
Thanks in advance. with regards Barani |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wall function for velocity? | johnblund | OpenFOAM | 3 | September 6, 2022 07:22 |
Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
Need some wall function approaches! | yka8150 | Main CFD Forum | 0 | September 21, 2009 23:08 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |