|
[Sponsors] |
July 19, 2013, 07:12 |
Reference values
|
#1 |
New Member
Vipin
Join Date: Jul 2013
Posts: 4
Rep Power: 12 |
Dear sir
I am calculating Average Nusselt Number in Fluent.... I am changing the reference value ..... what is the effect of reference value on solution? How to set it with reference to a problem? I am simulating 2D rectangular duct with Heat flux is given at middle of duct inlet temp= 300 k i am changing reference temp to some other values..... help me..... |
|
July 20, 2013, 12:46 |
|
#2 |
Super Moderator
Alex
Join Date: Jun 2012
Location: Germany
Posts: 3,399
Rep Power: 46 |
The reference values in Fluent do not affect the solution. They are used for the calculation of dimensionless numbers.
|
|
July 20, 2013, 13:00 |
|
#3 |
New Member
Vipin
Join Date: Jul 2013
Posts: 4
Rep Power: 12 |
If I changed reference temp to get the required Nusselt Number ...is it a valid solution.
How to set reference temp for Nu no.? |
|
July 22, 2013, 04:20 |
|
#4 |
Super Moderator
Alex
Join Date: Jun 2012
Location: Germany
Posts: 3,399
Rep Power: 46 |
The reference values are those you would take if you calculated dimensionless numbers yourself.
You would not take 5m as a reference length to calculate the Reynolds number if the characteristic length of your flow setup was 1m. I know nothing about your heat transfer setup, but I guess the correct reference value for the temperature is the free stream temperature at the inlet. Or, since you obviously want to compare the results to another source, you should take the same temperature as in the reference work you are comparing to. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] difficulties installing swak4foam | newbie29 | OpenFOAM Community Contributions | 120 | October 21, 2022 04:01 |
Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
It would be wonderful if a tool for FoamToTecplot is available | luckyluke | OpenFOAM Post-Processing | 165 | November 27, 2012 06:54 |
Reference Values | Lilly | FLUENT | 1 | May 31, 2012 09:51 |
OpenFOAM 1.6-ext git installation on Ubuntu 11.10 x64 | Attesz | OpenFOAM Installation | 45 | January 13, 2012 12:38 |