|
[Sponsors] |
November 27, 2013, 03:46 |
Ideas for distorted model
|
#1 |
Member
Iman
Join Date: Nov 2013
Posts: 37
Rep Power: 12 |
I'm Following dimensional analysis for scaling down wastewater piping system. to meet all the required similarities the pipe diameter is very large. I would like to reduce the length and diameter but following scientific basis and with ability to justify the distortion since the model will be used for validation if simulation work.
could you please provide me with some ideas/good sources on how to work with scaling and about distorted models. thank you in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
gamma-ReTheta turbulence model for predicting transitional flows | FelixL | OpenFOAM Programming & Development | 123 | August 30, 2022 11:50 |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
Problem importing watertight model into CFX | djk1301 | ANSYS | 3 | February 1, 2011 22:04 |
Reynolds Stress model in CFX vs Fluent | Tim | CFX | 1 | October 7, 2009 06:19 |
multi fluid mixture model issue | rystokes | CFX | 3 | August 9, 2009 19:13 |