|June 7, 2007, 05:01||
I need some comment regarding to stress analysis of maching weel ring, i put its geometry on this link:
- is it possible to consider this part in service condition as static (i need relative stress distribution, not accurate)?
- if we consider static condition, what is stress-displacement boundary condition on boundaries 1-4?
- i think that traction-free bc for 2 and 4, zero displacement for 1 and stress (along x) for bc 3 is feasible, is this correct?
- is any volumetric body force is required for stress analysis of this part?
|Thread||Thread Starter||Forum||Replies||Last Post|
|[Other] Creep Analysis for Stress cell usning ANSYS-WORKBANCH..||sidspark12||ANSYS Meshing & Geometry||1||December 26, 2012 05:29|
|Contact problem (boundary condition) for stress analysis||Hisham||OpenFOAM Pre-Processing||2||September 21, 2011 05:56|
|Stress and flow analysis together||Eferal||OpenFOAM||3||April 25, 2011 10:32|
|CFX-Structural thermal stress analysis||Ravikiran||CFX||1||February 22, 2010 09:57|
|stress analysis of a rotating beam(wind blade)||Cheyannne||ANSYS||0||October 19, 2009 17:06|