|
[Sponsors] |
mesh file from Autoform software into ANSYS-FLUENT |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 11, 2014, 13:38 |
mesh file from Autoform software into ANSYS-FLUENT
|
#1 |
New Member
AZ
Join Date: Jan 2014
Posts: 17
Rep Power: 12 |
Hi everybody,
are we able to get a mesh file from Autoform software and read that into ANSYS-FLUENT? I would like to simulate at different times what is the pressure and velocity for different meshes of the autorm mesh. I believe I can take an ASCII file and use that.... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 10:59 |
[swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
friction forces icoFoam | ofslcm | OpenFOAM | 3 | April 7, 2012 10:57 |
2.0.x on Mac OSX | niklas | OpenFOAM Installation | 74 | March 28, 2012 16:46 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |