 |
 |
 |
|
|
|
[Sponsors] | ||||
September 3, 2008, 04:45
|
load a file.msh
|
#1 |
|
Guest
Posts: n/a
|
whe I try to load a .msh file appears this message:Error read face.... Reading Faces:failed while read section What can it be? Originally I can load this mesh,but it presents a strange spacing along a part of the edge so I re-mesh my volume.
|
|
|
||
|
September 3, 2008, 07:02
|
Re: load a file.msh
|
#2 |
|
Guest
Posts: n/a
|
Which software is it ? Fluent ???
|
|
|
|
||
|
September 3, 2008, 07:48
|
Re: load a file.msh
|
#3 |
|
Guest
Posts: n/a
|
If the software is fluent, that may be because of an essential error in meshing the geometry. check the mesh again and repair it!
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM] How to load all <case>/surfaces/*/*.vtk at once into Paraview | holodeck10 | ParaView | 8 | November 22, 2019 17:52 |
| How to model concrete slab in ANSYS and apply 2 million cyclic load. | jjc | ANSYS | 3 | April 12, 2011 04:47 |
| moving load problem | aditi chauhan | ANSYS | 0 | October 9, 2010 04:47 |
| Strarting load step number | KtoTo | Siemens | 2 | June 21, 2007 09:01 |
| Using load vector for parallel partitioning | Kevala | FLUENT | 0 | May 1, 2001 12:11 |
Linear Mode
