|
[Sponsors] |
August 28, 2015, 10:33 |
Conservation of kinetic energy
|
#1 |
Senior Member
Join Date: May 2012
Posts: 548
Rep Power: 15 |
Hey,
I am doing a kinetic energy conservation test for my colocated code and have a question regarding the setup. Mesh: 33x33 I use periodic boundary conditions with a Taylor vortex initial condition. The kinetic energy is dissipated if the initial velocities are too high, but if I make sure that they are low then there is no dissipation of kinetic energy. What may be the cause of this? (some Peclét number violation?) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to exploit SGS kinetic energy with Smagorinsky model in LES | babakflame | OpenFOAM Programming & Development | 3 | December 14, 2014 06:58 |
A question about filtered kinetic energy | 8cold8hot | Main CFD Forum | 0 | November 2, 2014 01:56 |
How to view subgrid kinetic energy | Craig | FLUENT | 3 | September 8, 2012 11:34 |
Kinetic Energy Conservation | longamon | OpenFOAM Running, Solving & CFD | 1 | May 28, 2011 02:08 |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |