 |
 |
 |
|
|
|
[Sponsors] | ||||
February 22, 2017, 18:01
|
Skewed Multi nozzle mesh
|
#1 |
|
New Member
Hashim Chishty
Join Date: Feb 2017
Location: United Kingdom
Posts: 1
Rep Power: 0  |
Hi guys, I am modelling a cooling system that consists of a main flow inlet into a rectangle type domain of which 27 cold flow tubes are inserted. The mesh is giving me problems as it is skewed to 0.98. I have managed to run it with relaxation factors switched on but I find that the near wall effects are not captured. Any idea on how to mesh the tubes? I have attached the geometry, thx
|
|
|
|
|
 |
| Tags |
| cooling, mesh, nozzle, skewed |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multi subset mesh motion | hchen | OpenFOAM Running, Solving & CFD | 3 | March 5, 2022 23:41 |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| [ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters) | shubham jain | ANSYS Meshing & Geometry | 1 | April 10, 2017 05:03 |
| [snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 16:59 |
| help: the volume mesh has highly skewed elements | xiaofish | FLUENT | 3 | September 18, 2007 09:51 |
Linear Mode
