|
[Sponsors] |
March 10, 2017, 02:17 |
How can I get a low residual value?
|
#1 |
New Member
Lee Ji hyun
Join Date: Mar 2017
Posts: 1
Rep Power: 0 |
Hello.
I want to lower the residual value. 3D problem, and Pressure-Far-Filed speed is 0.01 Mach. My guess is that the residual value is measured high because the speed is slow. Is there any good way to lower the residual value? Turbulence Model: K-epsilon, Realizable Solver type: Density-Based Energy on Species Transport |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 02:20 |
Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 13:12 |
pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 06:37 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |