|
[Sponsors] |
How to model a long slit type spray cooling arrangement? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 10, 2018, 02:46 |
How to model a long slit type spray cooling arrangement?
|
#1 |
New Member
Sagar
Join Date: Sep 2017
Location: Surat, India
Posts: 10
Rep Power: 8 |
Dear All,
I want to setup a case for CFD simulation of flat plate spray cooling arrangement. In my experimental setup, there is one long slit type sprayer and it is a spray of gravity driven water and high pressure air. I have the flow rate of water and air at the inlet as well as pressure of blower. I am attaching an image which shows the arrangement of slit and moving plate. I try to model it with DPM flat fan atomizer model. But I am not clear about what type of atomizer I should use? Apart from inlet flow rates, pressure and velocity of plate what are the other input parameters I have to decide to setup DPM model? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 00:21 |
Problem with continuity simpleFoam kkl omega airfoils | ibelunatic | OpenFOAM Running, Solving & CFD | 0 | March 20, 2018 11:48 |
[Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam) | Aadhavan | OpenFOAM Meshing & Mesh Conversion | 2 | March 8, 2018 01:47 |
multiphaseEulerFoam/tank discharge | ves | OpenFOAM Running, Solving & CFD | 8 | December 31, 2017 14:59 |
Pressure instability with rhoSimpleFoam | daniel_mills | OpenFOAM Running, Solving & CFD | 44 | February 17, 2011 17:08 |