Home > Forums > General Forums > Main CFD Forum

Star-cd:Refine mesh in cylindrical coordinate system

Mark Forums Read

Reply

Search this Thread

May 11, 2000, 08:17	Star-cd:Refine mesh in cylindrical coordinate system	#1
Moussa Diarra Guest Posts: n/a	Hello, i have a cylindrical sector and i would like to refine the inferior part of my cylinder only in r and z direction (the coordinates are r,angle,z). This is normally done by : CREF 2 1 2 CSET The command is done successfully except near the centre of my cylinder where prostar divide some cells in Theta direction. If you already encounter this problem can you help? Star-CD version 3.10

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
Cylindrical cordinate system	hamoudi	STAR-CD	2	July 24, 2009 11:00
Cylindrical cordinate system	hamoudi	CFX	0	July 23, 2009 02:28
staggered mesh in curvlinear coordinate system	frederic felten	Main CFD Forum	0	April 10, 2000 15:28

All times are GMT -4. The time now is 12:48.