|
[Sponsors] |
April 16, 2019, 02:46 |
Q1 Process error in Converge
|
#1 |
Member
Pradeep
Join Date: Nov 2014
Posts: 45
Rep Power: 11 |
Hi there. I ran a closed cycle diesel combustion using SAGE model and i receive this Q1process error and the simulation ends.
I have attached the snap for your reference. Thank you in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
From Gambit to Converge ic-engine duel fuel simulation | mohameditdh | CONVERGE | 5 | November 14, 2017 18:37 |
A general interface question about two phasing simulation using CONVERGE | tmy | CONVERGE | 1 | November 7, 2017 15:54 |
Problem running in parralel | Val | OpenFOAM Running, Solving & CFD | 1 | June 12, 2014 02:47 |
error 262144 and unexpected disconnect when run on 2 nodes | Emily1412 | SU2 Installation | 1 | April 10, 2014 17:08 |
How to setup a simple OpenFOAM cluster? | TommiPLaiho | OpenFOAM Installation | 3 | October 27, 2013 15:15 |