|
[Sponsors] |
May 15, 2019, 14:49 |
CFD study on louver
|
#1 |
New Member
Jayakrishnan
Join Date: May 2019
Posts: 3
Rep Power: 7 |
I'm doing my undergraduate final year project as a study on louver. The geometry meshing and setup is done. In the solution however a negative pressure (in pressure contour,static pressure) is seen on the tip of louver blades. There are a total of 13 louver blades in my setup and only the lower ones show the negative pressure. Is there anyway I can avoid this ?. The inlet condition was given velocity inlet at 1.7m/s and pressure outlet as outlet.
|
|
Tags |
louver, negative pressure, vacuum |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFD Design...The CFD Future | John C. Chien | Main CFD Forum | 20 | November 20, 2015 00:40 |
Understanding CFD Tracer Study Simulation Data | Tracer | FLUENT | 2 | October 15, 2014 14:20 |
Free CFD setup for Simple ventilation study | gcchui | Main CFD Forum | 0 | April 24, 2013 07:56 |
Starting Point to study CFD and code writing | Lynn | Main CFD Forum | 3 | November 23, 2005 05:31 |
CFD study for a MAV(Micro Air Vehicle) | raj | Main CFD Forum | 3 | June 14, 1999 21:29 |