|
[Sponsors] |
Regarding adding initial gas fraction in CHEMKIN PFR model |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 1, 2020, 17:35 |
Regarding adding initial gas fraction in CHEMKIN PFR model
|
#1 |
New Member
iamascientist
Join Date: May 2020
Posts: 1
Rep Power: 0 |
Hello users,
I am trying to simulate the PFR model in ANSYS CHEMKIN for Reforming of methane over Ni surface. I want to give an initial gas fraction of Ar 1.0 in C1_PFR--->Species specific properties before giving CH4 1.0 in C1_inlet--> Species-specific properties--> reactant inlet. This option is available in the PSR model but it doesn't exist in the PFR model. Kindly give your valuable suggestions on how to insert this parameter in ANSYS CHEMKIN. Regards, Raj |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Maximum number of iterations exceeded chtmultiregionsimpleFoam | Moncef | OpenFOAM Running, Solving & CFD | 28 | July 13, 2020 14:26 |
laplacianFoam with source term | Herwig | OpenFOAM Running, Solving & CFD | 17 | November 19, 2019 13:47 |
pressure in incompressible solvers e.g. simpleFoam | chrizzl | OpenFOAM Running, Solving & CFD | 13 | March 28, 2017 05:49 |
pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 06:37 |