 |
 |
 |
|
|
|
[Sponsors] | ||||
July 9, 2020, 09:54
|
plotting data in paraview
|
#1 |
|
New Member
Mudit Mehta
Join Date: Jun 2020
Posts: 19
Rep Power: 4  |
Hello, i have simulated flow past a circular cylinder in OpenFOAM at Reynolds Number 100. I have plotted drag and lift coefficients using gnuplot. Now, i want to plot pressure coefficient (Cp) v/s theta in paraview. to validate my results. I have searched on internet how to do this but can't find suitable source.
Please help me to plot pressure coefficient. |
|
|
|
|
|
July 10, 2020, 06:12
|
|
#2 |
|
Senior Member
Troy Snyder
Join Date: Jul 2009
Location: Akron, OH
Posts: 207
Rep Power: 17 |
To plot over a curved surface, such as a cylinder, you apply the 'plotOnIntersectionCurves' filter.
|
|
|
|
|
|
 |
| Tags |
| cylinder laminar, parafoam, post procesing, pressure coefficient |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [General] Extracting ParaView Data into Python Arrays | Jeffzda | ParaView | 29 | January 18, 2023 07:37 |
| [General] Ordering XYZ data in Paraview | ellenvdveer | ParaView | 8 | July 3, 2016 21:04 |
| [General] Advice on post processing compressor blade data in paraview | Jack001 | ParaView | 0 | February 4, 2016 17:16 |
| [Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
| [OpenFOAM] extracting data from paraview | tharem | ParaView | 1 | January 17, 2011 23:45 |
Linear Mode
