|
[Sponsors] |
temperature profile won't update when using UNSTEADY IMPLICIT |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 10, 2020, 03:29 |
temperature profile won't update when using UNSTEADY IMPLICIT
|
#1 |
New Member
Ian
Join Date: Jul 2019
Posts: 17
Rep Power: 6 |
Hello everyone,
I've been doing this heat exchanger simulation for months and I tried out different turbulent models, solvers and mesh sets. The temperature profile updates when I use steady solver but the results are not very accurate compare to my benchmark values. So I tried to use the implicit unsteady solver to see if it gives me a better result. However, the temperature magnitude contour doesn't update when I use the unsteady solver. Same mesh set was used as I used steady solver. Can someone help me to resolve this issue? What could be the reason that causes this problem? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transient pressure and temperature boundary condition profile inicialization | Aurora23 | FLUENT | 2 | April 21, 2015 16:01 |
UDF to update C_T(c,t) with Unsteady Flamelet Values | clarkie_49 | Fluent UDF and Scheme Programming | 5 | September 19, 2013 17:27 |
Temperature Profile through a fluid solid interface | Studentdrak | CFX | 4 | January 31, 2012 22:23 |
Using a boundary profile file with unsteady, spatially varying data | jonnythewlis | FLUENT | 0 | December 8, 2009 15:49 |
unsteady inlet profile | Justin | Main CFD Forum | 0 | July 4, 2007 13:58 |