|
[Sponsors] |
calculating torque using cfd post processing results |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 7, 2020, 15:45 |
calculating torque using cfd post processing results
|
#1 |
New Member
wahba
Join Date: Aug 2020
Posts: 4
Rep Power: 5 |
hello there,
as doing simulation using ANSYS fluent on vertical wind turbine i need to calculate the torque i use function calculator from the post processing to find the torque on the blades the question is should i calculate it on every angle in transient mesh motion simulation? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Polyhedra and sliding mesh? | rockewan | FLUENT | 5 | December 1, 2018 19:07 |
Sliding / Dynamic Mesh in heat transfer problem | platzhalter | FLUENT | 0 | May 7, 2018 05:25 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |