|
[Sponsors] |
Prerequisite of using periodic boundary in the rotating machinery simulation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 6, 2021, 07:20 |
Prerequisite of using periodic boundary in the rotating machinery simulation
|
#1 |
Member
Rinia
Join Date: Jan 2018
Posts: 42
Rep Power: 8 |
Hey, CFDers
I'm performing a simulation about the wind tubrine, but I'm not sure if I can only model one blade in CFD with using the periodic boundary. This approach is common in the turbine simulation. However I haven't seen this application in wind turbine simulation. Anyone could give me some advice about the using of periodic boundary? Any help will be greatly appreciated. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
Problem in setting Boundary Condition | Madhatter92 | CFX | 12 | January 12, 2016 04:39 |
Boundary condition setting regarding turbine simulation using CFX | Lacerlacer | CFX | 11 | March 12, 2012 09:32 |