|
[Sponsors] |
January 19, 2022, 14:14 |
A problem with meshing a duct geometry
|
#1 |
New Member
omid
Join Date: Jun 2019
Posts: 15
Rep Power: 7 |
I just faced a problem with my fluid domain. As you see in the picture, there is a triangular area in the geometry which ansys mesher wont detect it's edges and twists the elements around that edge. I couldn't understand what is the problem with that edge!!
I'm also attaching the picture of my fluid domain, Does anyone have a general idea how can I have hex elements with infilation layers for this geometry? Thanks a lot for your attention |
|
Tags |
fluid, hex, mesh, multizone meshing |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Problem with meshing complex geometry | Kelda | OpenFOAM Meshing & Mesh Conversion | 4 | April 16, 2020 10:21 |
SU2-7.0.1 on ubuntu 18.04 | hyunko | SU2 Installation | 7 | March 16, 2020 05:37 |
[ANSYS Meshing] CATIA Geometry Generation and Meshing | danielsullivan | ANSYS Meshing & Geometry | 0 | April 3, 2017 22:11 |
[ANSYS Meshing] Meshing problem in a constricted geometry | kozden | ANSYS Meshing & Geometry | 0 | December 18, 2013 04:39 |
[Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 05:53 |