[wjchoi]

After using salome utility to create geometry and mesh, to use these geometry and mesh created by salome, i used "ideasUnvToFoam".

when i made geometry and mesh, first, i made 2D geometry and then used "extrusion"(for 2D anlysis).

so i made them.

1) atmosphere 2) walls 3) lowerWall 4) inlet
--> (2D: line -- extrustion -->3D:face)

5) liquid
--> (2D: face --extrusion-->3D:volume)

so when i used the "ideasUnvToFoam", i wanted that the geometry from 1)~ to 4) are set into "boundary" respectly and 5) liquid to be "default patch".

however, unlike i intended, not only 5) liquid , but also 3) lowerWall is set into "default patch" not "lowerWall ("wall type" boundary condition)"

what sholud i do to solve this problem? thank you !

related code 

Found 1600 reversed boundary faces out of 3420
Of 3420 so-called boundary faces 60 belong to two cells and are therefore internal
Sorting boundary faces according to group (patch)
0: walls is patch
1: inlet is patch
2: lowerWall is faceZone
3: atmosphere is patch
4: liquid1 is cellZone
5: liquid2 is cellZone
6: liquid3 is cellZone

Constructing mesh with non-default patches of size:
    walls	110
    inlet	10
    atmosphere	40

--> FOAM Warning : 
    From function Foam::polyMesh::polyMesh(const Foam::IOobject&, Foam::pointField&&, const cellShapeList&, const faceListList&, const wordList&, const wordList&, const Foam::word&, const Foam::word&, const wordList&, bool)
    in file meshes/polyMesh/polyMeshFromShapeMesh.C at line 595
    Found 3200 undefined faces in mesh; adding to default patch.
Adding cell and face zones
 Cell Zone liquid1 	320
 Cell Zone liquid3 	800
 Cell Zone liquid2 	480
 Face Zone lowerWall 	20

End