|
[Sponsors] |
April 27, 2022, 15:06 |
Xflow
|
#1 |
New Member
Ahmed Kamal Alnemr
Join Date: Apr 2020
Posts: 8
Rep Power: 6 |
I am a beginner in CFD world, however I know the basics of each blackbox of any commercial software. but while I take an overview of xflow software I did not see any mesh generation and while I was searching about that I found that, this software is based on the Lattice Boltzmann method, thus I want why there is no meshing and also what is the relation between the mesh and that method.
thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Multiphase Flow Modeling using Xflow | yawar95 | Main CFD Forum | 0 | January 24, 2022 07:48 |
parallel processing in Xflow software | am69sh | Main CFD Forum | 1 | January 22, 2020 10:25 |
XFlow Academic Research or XFlow Academic Teaching | Beingzzz | Main CFD Forum | 0 | December 6, 2019 23:11 |
XFlow - noise generators | Above&Beyond | Main CFD Forum | 0 | May 11, 2016 03:00 |
XFlow file import problem | shakee93 | Main CFD Forum | 0 | June 10, 2015 03:10 |