|
[Sponsors] |
May 2, 2022, 08:31 |
Pointwise assemble special (domain)
|
#1 |
New Member
Join Date: Mar 2021
Posts: 13
Rep Power: 5 |
Hello,
I am trying to mesh a flatplate in 2D using a C-grid on Pointwise. However, when getting to the assemble domain stage, Pointwise is not able to generate the mesh and am not sure why. When trying a slightly different geometry (larger leading edge curve radius) it works just fine. I have ensured that the number of points in each domain side is identical and still does not seem to work. I have attached an image of what the setup looks like. If you have any alternative methods of meshing, that would also be appreciated. Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
Closed Domain Buoyancy Flow Problem | Madhatter92 | CFX | 6 | June 20, 2016 21:05 |
Monte Carlo Simulation: H-Energy is not convergating & high Incident Radiation | volleyHC | CFX | 5 | April 3, 2016 05:41 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |