|
[Sponsors] |
Marine resistance prediction using Star CCM plus |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 24, 2020, 20:00 |
Marine resistance prediction using Star CCM plus
|
#1 |
New Member
Taufiqul Islam
Join Date: May 2020
Posts: 1
Rep Power: 0 |
Hlw everyone,
This is my first post in this forum. Please ignore any mistake. I am trying to do a marine resistance prediction analysis using star ccm Plus. It is a tritoon boat. I followed all the steps in tutorial guide and done it more than 10 times. But every time my virtual towing tank displaces from the original location. I have followed each and every step described in tutorial and enabled the option for wave damping. But still getting the same error. I have attached an image of the distortion. Can anyone have a look at the image and tell me why this could happen and how to solve it? Regards Taufiq |
|
April 28, 2022, 15:27 |
|
#2 |
New Member
Tomasz Mruk
Join Date: Apr 2022
Posts: 1
Rep Power: 0 |
Hi
May I ask you to share with me virtual towing tank for STAR CCM+ which will be working with version 2021.1? I need this for my master thesis by cannot find nothing on the internet. Thanks in advance |
|
April 30, 2022, 07:34 |
|
#3 | |
New Member
Join Date: Oct 2021
Posts: 8
Rep Power: 4 |
Quote:
In that particular tutorial, you create the geometry of the towing tank yourself following the instructions in the tutorial (instructions are in the pdf manual, which also is to be found at the Support Center). |
||
May 18, 2022, 10:22 |
|
#4 | |
Member
Join Date: Jun 2014
Location: Turkey
Posts: 43
Rep Power: 11 |
Quote:
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Marine Propeller Hydroacoustic Simulation in Star CCM | BlackEagle | STAR-CCM+ | 1 | December 8, 2017 21:33 |
problem when imported geometry from 3D CAD to star ccm, | TAREK GANAT | STAR-CCM+ | 1 | May 21, 2013 22:15 |
[Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |