|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Vinay Nandurdikar
Join Date: Jun 2019
Posts: 2
Rep Power: 0 ![]() |
What's the difference between the following two surface reports for any variables such as velocity or pressure?
1. Area weighted average 2. Standard deviation |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
Join Date: Jun 2022
Posts: 11
Rep Power: 4 ![]() |
Area weighted average is the mean of all values at all points on a surface. Standard deviation is a quantity which describes how much the value at a point differs from the mean value.
|
|
![]() |
![]() |
![]() |
Tags |
#ansys#fluent#, #cfd-post |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
addressing and loading on non boundary surface in Pre Processor | Sobhan | CFX | 2 | October 23, 2021 15:22 |
[snappyHexMesh] snappyHexMesh generates not planar surface | krzychu111 | OpenFOAM Meshing & Mesh Conversion | 2 | April 23, 2020 17:38 |
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 12:05 |
[snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 08:05 |
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 07:47 |