Home > Forums > General Forums > Main CFD Forum

How to use Baldwin-Lomax Model in zone without wal

Mark Forums Read

Reply

Search this Thread

December 14, 2002, 01:23	How to use Baldwin-Lomax Model in zone without wal	#1
D .T. Guest Posts: n/a	y+,the distance to the wall,is the key parameter in the use of B-L turbulent model.But ,if the no wall exits in the computational zone, for exampe, wake zone after airfoil, how to use B-L model? thx

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
crack growth modelling implementing Cohesive Zone Model (CZM)	_Denis_	ANSYS	6	April 14, 2015 08:41
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 17:51
Recirculation zone over airfoil in SST model	Nick R	CFX	7	March 30, 2011 20:43
How to enforce positive values	Ning	Main CFD Forum	10	August 20, 2000 00:10
Fluent incident radiation problem	Michael Schwarz	Main CFD Forum	0	October 21, 1999 05:56

All times are GMT -4. The time now is 13:15.