flow in circular pipe

February 18, 2003, 11:00

Hi everybody,

I'm simulating a flow in a circular pipe that has an impeller inside it at a mid length. The pipe is strength and both ends are open. It's lie horizontal in the air, which pressure 101325 Pa. When the work apply to impeller. The boundary condition of the outlet of the pipe is set to static pressure 0.0 Pa.( reference to ambient pressure). Which the inlet boundary condition should i set to the inlet portion. Give me a suggestion please.

Jackie

February 18, 2003, 12:58

Oh I see! It's must be a zero total pressure.

February 18, 2003, 11:00	flow in circular pipe	#1
Jackie Guest Posts: n/a	Hi everybody, I'm simulating a flow in a circular pipe that has an impeller inside it at a mid length. The pipe is strength and both ends are open. It's lie horizontal in the air, which pressure 101325 Pa. When the work apply to impeller. The boundary condition of the outlet of the pipe is set to static pressure 0.0 Pa.( reference to ambient pressure). Which the inlet boundary condition should i set to the inlet portion. Give me a suggestion please. Jackie

February 18, 2003, 12:58	Re: flow in circular pipe	#2
Jackie Guest Posts: n/a	Oh I see! It's must be a zero total pressure.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Disturbed flow field at outlet boundary (Multiphase flow through pipe)	Michiel	CFX	17	April 21, 2010 10:14
steam flow in a pipe driven by a pressure gradient between inlet and outlet	SalvoCalvo	COMSOL	0	March 11, 2010 06:52
outlet boudary condition for a flow in the pipe	Atit	CFX	2	November 9, 2004 17:43
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 09:11
Hydrostatic pressure in 2-phase flow modeling (long)	DS & HB	Main CFD Forum	0	January 8, 2000 15:00