|
[Sponsors] |
March 22, 2004, 15:52 |
I have problem in Airpak
|
#1 |
Guest
Posts: n/a
|
Hi all I am student using airpak for analysis of flow of contaminated air in the room. my problem are as follows:
1.By running steady state flow : I find out the mass flow in and out the room does not balance ..what can be a problem here.. 2. I specified a certain flow and I need them to remain constant all the time but the result shows the specified flows have other values some less and other great than specified ones; what is going wrong here 3.when checking the flow through walls ; I discovered that some cells on the wall there is flow through them, although the total mass flow throw the wall is remain zero as required, can this cause an problem in my analysis?? 4. When checking the flow vectors I see that some opening allow flow-in at the bottom of the opening and allow flow-out at the top. but in reporting I get only one value which showing that the flow out or in; is this value a net value of the flow to that particular opening or and average one..?? so how can I balance the each component of the system..??? please I need your help on these problems so I can go forward with my work Rajabu |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Problem in implementing cht | tilek | CFX | 3 | May 8, 2011 08:39 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |