from point clouds to surface/volume

waters · April 6, 2010, 10:07

Dear all,

I am quite new in cdf. I have a cloud point file which I am able to import to the DesignModeler. I have been trying to use this data to create a surface, eventually a volume, in order to be able to create a big mesh an then do some simulations in FLUENt. Is it possible to achieve this using only ANSYS 12 software? Any ideas?

Thank you for your time,

waters

waters · February 5, 2011, 10:16

I posted this a long time ago, but if any interested, points2poly did the job. I found later that there are some matlab/octave scripts that create .stl's from point cloud data.
Once with .stl, snappyhexmesh makes everybody smile.

April 6, 2010, 10:07	from point clouds to surface/volume	#1
waters New Member carlos Join Date: Apr 2010 Posts: 8 Rep Power: 16	Dear all, I am quite new in cdf. I have a cloud point file which I am able to import to the DesignModeler. I have been trying to use this data to create a surface, eventually a volume, in order to be able to create a big mesh an then do some simulations in FLUENt. Is it possible to achieve this using only ANSYS 12 software? Any ideas? Thank you for your time, waters

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFX Post: Problems with moving point cloud for changing time steps	spatialtime	CFX	0	December 7, 2009 05:56
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 08:36
[Gmsh] Gmsh and samplesurface	touf	OpenFOAM Meshing & Mesh Conversion	2	December 10, 2007 03:27
Merging volumes created from imported point clouds	Nicklas Törnblom	FLUENT	1	October 23, 2004 02:15
CFX4.3 -build analysis form	Chie Min	CFX	5	July 13, 2001 00:19

February 5, 2011, 10:16		#2
waters New Member carlos Join Date: Apr 2010 Posts: 8 Rep Power: 16	I posted this a long time ago, but if any interested, points2poly did the job. I found later that there are some matlab/octave scripts that create .stl's from point cloud data. Once with .stl, snappyhexmesh makes everybody smile.