|
[Sponsors] |
June 24, 2004, 16:41 |
dynamic meshing option
|
#1 |
Guest
Posts: n/a
|
HI, I am intrested to simulate a dynamic stall on naca 0015 using fluent 6.1.(dynamic meshing option).Is there someone who already has used this option ( DYNAMIC MESHING OPTION).IF so please guide me to make a mesh(since it has few particular requiremnts for moving portion ).Anything would be great.Thanks in advance
|
|
June 25, 2004, 18:45 |
Re: dynamic meshing option
|
#2 |
Guest
Posts: n/a
|
For using the dynamic grids, make sure ur grid is fine enuf and the minimum volume of the grid should go on par with ur declaration in the dynamic mesh option.
Choose remeshing and follow Fluent instructions to initialize smoothing procedures. Thinks should be ok ! And after all these, make sure ur time step is corresponding smaller than ur air foil motion ! Cheers CFDtoy |
|
June 26, 2004, 04:59 |
Re: dynamic meshing option
|
#3 |
Guest
Posts: n/a
|
hi, thanks for ur reply.Do i need to make a stationary or moving faces separately then interface them using non -conformable interface option. have u used this option ( dynamic mesh ) using fluent 6.1 becasuse i am facing problem in making mesh. thanks
|
|
June 26, 2004, 14:50 |
Re: dynamic meshing option
|
#4 |
Guest
Posts: n/a
|
hello
I have used Dynamic Meshes in 3D and its more complicated in any 2D case since the time step has to be more than accurate. I reckon you are working on a 2D case ( face moving ), jus make the face moving and you can read abt the non comformable interface in the Fluent manual ..if it is required for your case. Jus make a moving face and run the code to see the grid motion. Cheers CFDtoy |
|
June 27, 2004, 03:55 |
Re: dynamic meshing option
|
#5 |
Guest
Posts: n/a
|
hi, thanks for your reply.do i need to make the moveable(around the airfoil) and stationary faces ( inlet and outlet) and then hook them by using non -conformable option. or to make just one face ( entire domain including the airfoil). thanks for taking your time .
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fatal error | Echidna | CFX | 4 | September 13, 2016 06:50 |
CFX does not continue | Shafiul | CFX | 10 | February 17, 2011 08:57 |
increasing mesh quality is leading to poor convergence | tippo | CFX | 2 | May 5, 2009 11:55 |
Vessel Residence Time Distribution Help | Davo | CFX | 3 | December 19, 2006 04:36 |
about compresive phase | James | CFX | 10 | September 12, 2006 04:16 |