|
[Sponsors] |
March 30, 2012, 10:22 |
Floating point error: Invalid number
|
#1 |
New Member
zaki
Join Date: Mar 2012
Posts: 1
Rep Power: 0 |
I am simulating one rotating cylinder at higher temperature inside another (outer) stationary cylinder at (comparatively) lower temperature with fluid flowing between the two cylinders but whenever i specify the mass flow rate from periodic conditions the error appears saying Floating point error: Invalid number. Please tell me how can i avoid the error and still specify the ass flow rate.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
MPI Error - simpleFoam - Floating Point Exception | scott | OpenFOAM Running, Solving & CFD | 3 | April 13, 2012 16:34 |
DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
Floating point exception: Invalid number | Jinfeng | CFX | 4 | January 11, 2009 16:44 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |