|
[Sponsors] |
December 7, 2013, 10:02 |
how can i use a set of node points
|
#1 |
New Member
Join Date: Jul 2013
Posts: 2
Rep Power: 0 |
I have a 2D triangular mesh generator that takes in a 2d image with an object of interest inside (like an airfoil or profile of a car) and outputs x and y coordinates for all of the node points. It can also output the three vertices for each triangle. Aside from a plot of these coordinates connected with lines, that's all I have for a mesh. There is a defined rectangle around the object in the image which could serve as boundaries.
Is there any way I can import that to a mesh generation software that will allow me to apply boundary conditions and output something useful to a solver like fluent or OpenFOAM? |
|
December 9, 2013, 17:25 |
|
#2 | |
Senior Member
Chris DeGroot
Join Date: Nov 2011
Location: Canada
Posts: 414
Rep Power: 17 |
Quote:
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How set experimental points values as wind tunnel boundary conditions | vidade | FLUENT | 3 | December 23, 2012 16:02 |
How to show the transient case? | H.P.LIU | Phoenics | 7 | July 13, 2010 04:31 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
how to set velocity on node | tipakorn | Siemens | 3 | January 23, 2008 05:05 |