|
[Sponsors] |
March 18, 2015, 13:04 |
Pseudo 3D mesh by Gmsh for OpenFOAM
|
#1 |
Member
X Meng
Join Date: Jun 2012
Location: Scotland
Posts: 89
Rep Power: 13 |
Hi there,
I am really screwed by a problem recently. When I try to generate a pseudo 3D mesh for OpenFOAM, it is really strange that if extrude a plane with some points, it will be not ok to generate three dimensional mesh with one layer. The message 'Could not find vertex (x,y,z) in surface XXX' is always shown. Does anyone have same problem? Many thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
[Gmsh] problem converting mesh from gmsh | Fried | OpenFOAM Meshing & Mesh Conversion | 8 | October 18, 2011 08:53 |
[Gmsh] gmshToFoam problem: not the same mesh in Gmsh vs. paraview | zhernadi | OpenFOAM Meshing & Mesh Conversion | 8 | July 7, 2011 02:28 |