 |
 |
 |
|
|
|
[Sponsors] | ||||
Meshing inclined cylinder with PBC tetra mesh ICEM |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 26, 2015, 18:01
|
Meshing inclined cylinder with PBC tetra mesh ICEM
|
#1 |
|
New Member
shashi
Join Date: Sep 2015
Posts: 3
Rep Power: 10  |
Hi,
I am fairly new to ICEM and CFD in general, I owuld like to mesh an inclined cylinder with periodic boundaries on the top and bottom of the cylinder (infinite cylinder), I tried setting the translation vector (the cylinder length vector from base to top) at the global mesh setup, but i get a mesh which is totally off! here's the .prj file attached. (the cylinder is inclined at 75 degrees to the flow direction, length = 1.5, so axis vec = 1.5cos(75),0,1.5sin(75) Thanks and Regards, shashi Last edited by shashi_soman; September 26, 2015 at 18:04. Reason: attach a file |
|
|
|
|
|
September 26, 2015, 18:05
|
|
#2 |
|
New Member
shashi
Join Date: Sep 2015
Posts: 3
Rep Power: 10 |
I wish to have this sort of mesh but periodic !
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
| Hexa + Tetra meshing (Hybrid) in ICEM | vmlxb6 | ANSYS Meshing & Geometry | 12 | December 27, 2010 10:18 |
| ICEM Tetra Meshing problme | kambireddy | ANSYS Meshing & Geometry | 3 | October 5, 2010 19:17 |
| [ICEM] ansys icem tetra mesh to fluent_v6 conversion problems | milleniumrider | ANSYS Meshing & Geometry | 5 | May 20, 2010 15:55 |
| [Commercial meshers] ansys icem tetra mesh to fluent_v6 conversion problems | milleniumrider | OpenFOAM Meshing & Mesh Conversion | 3 | May 13, 2010 14:54 |
Linear Mode
