|
[Sponsors] |
In Hypermesh a component with no free edges detected as a surface!? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 10, 2015, 12:24 |
In Hypermesh a component with no free edges detected as a surface!?
|
#1 |
New Member
sajjad
Join Date: Nov 2014
Posts: 3
Rep Power: 11 |
Hi,
I'm learning hypermesh. I'm trying to tetramesh a solid with hypermesh. the solid (it must be!) has no free edges. but the program detects it as a surface!. I tried autocleanup (maybe my parameters were wrong) and find free edges but no hope. I'm just curious what is wrong with the geometry? (or did I make a big mistake?) I would be pleased if someone can help me. the solid with all the shared edges is attached. Edit: In find edges, the program keep saying that "Elements have not been selected" dispite I choose the proper component. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh sticking point | natty_king | OpenFOAM Meshing & Mesh Conversion | 11 | February 20, 2024 09:12 |
Thermocapillary free surface flow | zakifoam | OpenFOAM Running, Solving & CFD | 10 | December 12, 2016 11:44 |
[snappyHexMesh] collapsed edges snappyHexMesh | ynos | OpenFOAM Meshing & Mesh Conversion | 1 | April 16, 2014 08:23 |
free surface model | sjtusyc | CFX | 3 | September 5, 2012 18:33 |
killed "snappyHexMesh" | parkh32 | OpenFOAM Pre-Processing | 2 | April 8, 2012 17:12 |