|
[Sponsors] |
May 18, 2016, 07:05 |
How to improve mesh quality of stirred tank
|
#1 |
New Member
Harshal
Join Date: Mar 2016
Posts: 2
Rep Power: 0 |
Hello all,
I am working on a mixing tank (with baffles) and Rushton turbine as impeller. I am using MRF technique. I am encountering the issue in mesh quality. I am getting skewness as follows Min skewness: 0.1305 max skewness: 0.896 Average skewness:0.2197 I would like to know which skewness factor should consider for mesh quality. whether the above mesh quality is acceptable? if no then any suggestions to improve mesh quality |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] How To Improve Pre Mesh Quality In O grid Based Double Pipe Cylinder | Shomaz ul Haq | ANSYS Meshing & Geometry | 6 | January 15, 2018 06:38 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
How to mesh stirred tank with hexahedral mesh? | boh_tea | FLUENT | 3 | March 15, 2011 03:48 |
Improve Mesh quality - airfoil simulation | Lukas84 | STAR-CCM+ | 4 | July 6, 2010 10:07 |
sliding mesh for stirred tank modelling | Gopal Kasat | FLUENT | 0 | June 24, 2005 05:38 |