Creating mesh interface zone in icem

flusk123 · May 24, 2017, 05:02

I am working on heat transfer problem where the geometry involves air zone and solid heat generation zone.

In Ansys Meshing, contact region is automatically created which is available in Cell zone conditions as well as mesh interface zones where we could define coupled wall

Can anybody help with how to define these contact regions/ fluid-solid interface zone in ICEM?

The geometry for both was created in DM and the solid zone was separated from air zone by Boolean subtract operation.

silambarasan7 · May 24, 2017, 07:22

Hi,
Once you complete the meshing split the interface into two by using following tool
Edit Mesh (tab) => Split mesh => Split Internal Wall...

Regards
Silambarasan

May 24, 2017, 05:02	Creating mesh interface zone in icem	#1
flusk123 New Member Join Date: May 2017 Posts: 4 Rep Power: 8	I am working on heat transfer problem where the geometry involves air zone and solid heat generation zone. In Ansys Meshing, contact region is automatically created which is available in Cell zone conditions as well as mesh interface zones where we could define coupled wall Can anybody help with how to define these contact regions/ fluid-solid interface zone in ICEM? The geometry for both was created in DM and the solid zone was separated from air zone by Boolean subtract operation.

May 24, 2017, 07:22	CFD Expert	#2
silambarasan7 Member sila Join Date: Jul 2013 Posts: 32 Rep Power: 12	Hi, Once you complete the meshing split the interface into two by using following tool Edit Mesh (tab) => Split mesh => Split Internal Wall... Regards Silambarasan subaru1989 likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
FLUENT adding mesh nodes problem when importing 3D mesh from ICEM	guxin7005	FLUENT	2	June 27, 2016 21:41
[ICEM] Export ICEM mesh to Gambit / Fluent	romekr	ANSYS Meshing & Geometry	1	November 26, 2011 12:11
Problem in IMPORT of ICEM input file in FLUENT	csvirume	FLUENT	2	September 9, 2009 01:08