Home > Forums > Special Topics > Mesh Generation & Pre-Processing

How to make conformal FSI mesh using GMSH

Mark Forums Read

Like Tree

1Likes

1 Post By jijoderick

Reply

Search this Thread

May 31, 2022, 06:15	How to make conformal FSI mesh using GMSH	#1
jijoderick New Member Jijo Derick Abraham Join Date: May 2018 Location: INDIA Posts: 2 Rep Power: 0	Hi all, How we can make a conformal mesh for a three-dimensional tube (as shown below) using gmsh for Fluid-structure simulation (FSI). I need separate meshes for the solid and fluid domains and the interfaces should be conformal. Thanks in advance sherlock45 likes this.

May 31, 2023, 18:12		#2
sherlock45 New Member Deshik Join Date: Jun 2021 Location: India Posts: 5 Rep Power: 5	https://gitlab.onelab.info/gmsh/gmsh/-/issues/1150 Hope this helps.. Works well for simple geometries

Reply

Tags

conformal meshes, fsi interface

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
foam-extend-4.1 release	hjasak	OpenFOAM Announcements from Other Sources	19	July 16, 2021 05:02
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38
compiling firefoam	Farshad_Noravesh	OpenFOAM	27	December 24, 2012 04:21
how to extend FSI 2D codes to 3D, need advises	abouziar	Main CFD Forum	1	May 30, 2008 04:08

All times are GMT -4. The time now is 21:12.