|
[Sponsors] |
November 29, 2022, 03:43 |
Re-mesh on Salome
|
#1 |
Member
Giovanni Medici
Join Date: Mar 2014
Posts: 48
Rep Power: 12 |
Hi all,
I’d like to know whether it is possible to remesh after modifying / deleting few volumes in SALOME. Alternatively is it possible to create a mesh object not from a geometry but from a set of (meshed) groups? Basically I'd like to create a script that meshes (3D) with Viscous Layers that collapse at the end of the face (imagine a 3D wing, I’d like the inflation layer to collapse progressively when reaching the trailing edge). To do so I though about the following procedure:
Repeat 2. to 8. until the final inflation layer (viscous 3D Layer) is created. By using the GUI (but it should be fairly easy to automatize), I managed to do points 1. to 7. Thanks! Any help / hint is highly appreciated! |
|
Tags |
python script, re-meshing, salome, viscous layer |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 13:05 |
[snappyHexMesh] non uniform mesh near the stl object | vava10 | OpenFOAM Meshing & Mesh Conversion | 0 | January 31, 2021 14:41 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
Salome cgns format mesh to SU2 | JPBLourenco | SU2 | 19 | November 18, 2019 02:11 |
[snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water! | divergence | OpenFOAM Meshing & Mesh Conversion | 0 | January 23, 2019 04:17 |