[wkjshon]

Dear all,

A tricky problem...
I'm using Fine/Turbo 10.1 now. There's a problem that makes me really confusing.
When I used the file that was built by Autogrid as the grid file for the Fine/Turbo case, everything was fine.
However, when I used the file that was built by IGG as the grid file for the Fine/Turbo case, the grid couldn't be recognized and there was a warning said "The grid configuration file does not contain all the blocks defined in the mesh file."
I've checked the configuration file, and found nothing wrong.
I tried to build a new igg file that only contains one single block. But the the same error occured.
I also tried an older version Fine 9.13. Still the same error.
I have to use IGG to generate the Volute Mesh of the Compressor. But the Fine/Turbo cannot open the grid!
Did someone have the similar problem? Please help me......
Desperate.....

Thanks in advance,
Jessica