the problem to generate grids for turbine in Numeca

X.Y. Liu · October 29, 2018, 01:27

hi,everyone,
when i use Numeca>Autogrid5 to generate grids for turbine, i meet the problem that "main blade: trailing edge does not intersect shroud", i find There is a gap between blade and shroud in fact, so, how can I extend the length of the blade to intersect shroud in Autogrid5 ？any advise? thank you very much!

Hamidzoka · October 31, 2018, 02:08

hi;
It has a simple solution!
on the rows list on left side of AG5 right click on "main blade" then select "geometry" and then "expand". By adjusting expansion factor you can let the blade intersect both shroud and hub curves which is necessary for meshing in AG5.
Note that depending on your software version the way you can get the "expand" option may be a little different!

October 29, 2018, 01:27	the problem to generate grids for turbine in Numeca	#1
X.Y. Liu New Member Join Date: Oct 2018 Posts: 1 Rep Power: 0	hi,everyone, when i use Numeca>Autogrid5 to generate grids for turbine, i meet the problem that "main blade: trailing edge does not intersect shroud", i find There is a gap between blade and shroud in fact, so, how can I extend the length of the blade to intersect shroud in Autogrid5 ？any advise? thank you very much!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Connectivity problem with grids created using gmsh	shank19	SU2	3	May 10, 2017 08:54
Heat Transfert, mixing problem	Wazdq	CFX	8	November 7, 2016 05:44
problem related to staggered grids	zhu	Main CFD Forum	10	October 27, 2001 22:30
extremely simple problem... can you solve it properly?	Mikhail	Main CFD Forum	40	September 9, 1999 09:11
unstructured vs. structured grids	Frank Muldoon	Main CFD Forum	1	January 5, 1999 10:09

October 31, 2018, 02:08		#2
Hamidzoka Senior Member Hamid Zoka Join Date: Nov 2009 Posts: 282 Rep Power: 18	hi; It has a simple solution! on the rows list on left side of AG5 right click on "main blade" then select "geometry" and then "expand". By adjusting expansion factor you can let the blade intersect both shroud and hub curves which is necessary for meshing in AG5. Note that depending on your software version the way you can get the "expand" option may be a little different!